The main factor that affects the crushing fineness of the airflow crusher 1. In general, the nature of the material is generally the crushing of all crisp materials. However, due to the different properties of materials, its crushing performance is different. Because the strength, density, hardness, viscosity, shape, and electrical performance of various materials will definitely lead to differences in crushing results. The strength of the material is an important influencing factor. In addition, due to the excessive moisture content of certain materials or water content in the gas source, it will also change the performance of the crushed materials such as toughness and viscosity, which will affect the crushing fineness.
The airflow crusher is treated with the same material because the processing volume is different, and the fineness is different. Generally speaking, the processing volume is proportional to the product particle size. However, if the processing amount is too small, the chance of collision between particles is small, which will affect the fineness. The working pressure of gas crushing machine gas is crushing, which uses the pressure of the fluid to convert to speed energy. Therefore, the greater the gas pressure, and the jet flow rate is relatively increased, which can increase the crushing energy, that is, the crushing effect. The particle size of the product is different due to different feed particles. Of course, the smaller the grid size of the feed, the smaller the particle size of the product. If the particle size distribution of the raw materials is relatively consistent, the fineness and particle size distribution of the product is better. If the particle size distribution is wide and the thickness and disparate are disparate, the result of the collision between thick particles and fine particles in the crushing process will inevitably affect the crushing effect Essence Due to the differences in the nature of various ingredients in the mixture, the single material and mixture of the air flow crusher will produce a soft and hard granules or high -strength and low -intensity particles when crushing, which may affect the shattering effect. The airflow crusher is mainly composed of airflow crusher, whirlwind collector, dust collector, reinforcement fan, electronic control cabinet, etc. The airflow crusher is mainly suitable for crushing mechanisms. It has a wide range of applications and has a high fineness of the finished products. Typical materials such as high -pure ceramic pigments and biochemicals such as ultra -hard hard diamond silicon carbide metal powder. Because of this, it will be available in school hospitals and even families. What are the reasons for the small air flow crusher of the laboratory? The working principle of the air flow crusher is to convert the air from the air source into nitrogen, carbon dioxide and other inertial materials, and the temperature requirements of the medical PVC. Gas can make the machine a inert gas protection equipment, which is suitable for crushing and classification of materials that are susceptible to oxidized.